2019-2020 Toyota Corolla Hatchback - Front Bumper Accent Under Eyelid Overlay
The 2020 Corolla's have an aggressive to begin with, but what if you took it a step further. The easiest way to make a drastic difference is to accent the sharp body lines present on the front bumper. This pre-cut vinyl overlay falls right into place with little to no negotiation as you install it. Very easy DIY install can take as little as 2 minutes.It makes a huge visual difference up front especially on the lighter colored hatchbacks. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product
DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, line up the front corner of the overlay closest to the grille on the bumper as well as the body line that goes from the corner to the headlight. There is some excess towards the headlight on purpose for you to tuck under the headlight that way there is no white visible. Once the corner and inner edge is placed, line up the outer edge of the overlay with the outer edge of the curved body line on the bumper and let it fall into place. Set the material into place, let the far tip fall under the bottom of the headlight. Then, using a squeegee, start from the center of the overlay and apply firm pressure moving outwards. Continue with the squeegee until all air from underneath the vinyl is removed. No trimming should be required if placed properly.
Post heat the overlay, simply by letting your vehicle sit out in the warm sun for a couple of hours our, use a heat gun.
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
DIFFICULTY RATING 2/5
MORE >> Difficulty Rating Information